It must be wedding season again. My aunt called me up a week ago saying she was going to make a bridesmaid dress for a woman she does not know, and would not meet until the day of the wedding. She could not get a pattern in the same style as the other maids would have, and her challenge was to modify a pattern to make it look similar, as well as make it fit. The one thing she said she wasn't going to do was to try to make it a tulip sleeve like all the other girls would have. Over the phone, I could hardly argue the point, but I wanted to. Creating a tulip sleeve pattern would have been one of the easier tasks. In the end, the sleeve ended up being much too tight, and a gusset had to be added at the last minute to give her arm some space to move. Next time, I can direct her to this handy tutorial. No more tight sleeves please!
Tulip sleeves are an attractive and easy detail to add to any pattern with a set in sleeve. They are also very forgiving and comfortable to wear. To follow along with this tutorial, here is what you'll need:
- 2 pieces of wax paper (any paper that is transparent will work) sufficient for sleeve width and projected length.
- a medium tip Sharpie or Permanent Marker.
- Rulers to make straight and curved lines.
- transparent tape- removable photo tape works best. I use push pins with a foam core board.
2. Cover the pattern with one sheet of paper. Tape it down or tack in place so it does not slide, as you'll be tracing the original pattern off. First one side, then the other.
To assemble the sleeve, sew fashion fabric, right sides together at the underarm seam first. Do the same with the lining. With the sleeve flat, facing up, lay the lining on top, with right sides together. It is very easy to get the sides mixed up because they look the same except for the notches. Add a piece of masking tape to the wrong side and mark each side if you think this might happen to you. Pin the lining to the sleeve along the bottom edge. Beginning at the top of the front cap, sew aroun the bottom, under the arm, up to the top of the back cap. Trim, press, and understitch on the lining side. Press again, having the lining and sleeve together. Now you are ready to overlap the two sides, matching the center symbol/and or notches. Pin the overlap and baste all the way around the sleeve, just to hold the layers together. Baste again from notch to notch as you normally would. The sleeve is now ready to put into your garment. It doesn't matter if the overlap is toward the front or the back. Just choose your favorite direction and be sure to do BOTH sleeves the same way!